23-418.fm Page 1 Friday, August 6, 1999 3:16 PM
7-Hour Ni-Cd/12-HourNi-MH Portable AA Battery Charger
Cat. No. 23-418
Your RadioShack Nickel Cadmium (NiCd) and Nickel Metal Hydride (NiMH) AA Bat-
tery Charger is designed to charge up to two each of both types of batteries or up to
four of one type (such as RadioShack Cat. No. 23-125, 23-149, or 23-525).
To charge four NiCd or Ni-MH AA batteries, install two batteries into each com-
partment as indicated by the polarity symbols (+ and –) marked inside each com-
partment, then set NiCd/Ni-MH switch to the appropriate setting.
Its features include:
illus of
battery
Two Charging Indicators — an indicator lights during charging for each battery
type, and turns off when charging is complete.
installation
Caution: Do not mix battery types.
Reverse Polarity Protection — protects the charger and batteries against damage
from incorrectly installed batteries.
2. Plug the charger into a standard AC outlet. The red indicator lights when you are
charging NiCd batteries, and the green indicator lights if you are charging NiMH
batteries.
Overcurrent Protection — protects the charger from damage if you try to charge
bad batteries.
illus of
charger
with outlet
OPERATION
1. To charge two NiCd or NiMH AA batteries, install both into one of the two charg-
ing compartments as indicated by the polarity symbols (+ and –) marked inside
the compartment, then set the NiCd/Ni-MH switch to the appropriate setting.
To fully charge completely discharged batteries, it takes 7 hours for NiCD batter-
ies and 12 hours for Ni-MH batteries.
3. When the batteries finish charging, unplug the charger from the outlet, then
remove the batteries from the charger. The indicator turns off.
Note: Both batteries must be installed in the same compartment.
© 1998 Tandy Corporation.
All Rights Reserved.
RadioShack is a registered trademark used by Tandy Corporation.
|