Before calling service
Refrigerator or freezer Compartments are warm
Display
• Allow your refrigerator to operate and cool down for 24 hours (1 full day) to reach
to the set temperature.
For details, refer to the user manual “Using the control panel”
• Also, when you put room temperature or warmer food into your refrigerator, it may
need an additional 24 hours for the fridge to reach the set temperature.
• Recommended Temp Settings
: -2°F for freezer and 38°F for refrigerator.
• Ice off : Press the “Ice Off” button to turn the ice making function off.
Moisture forms on outside/inside of refrigerator
• Wipe off the condensation with a dry towel (This may occur during hot and humid
seasons.)
• If the condensation occurs on the doors, turn off the Energy Saving function.
• If you open the doors frequently or for too long, it may cause moisture inside the
fridge.
Cooling Off mode
• Cooling Off (Show Room) mode : If the Display shows the “0F 0F” code, it means
that the Cooling Off function is activated and the refrigerator is not cooling. To can-
cel this mode, press the Power Freeze and Freezer buttons at the same time for
3 seconds until a “Ding-dong” sound is heard and the unit will now cool.
Noise Clicks, Pops, Cracks, Snaps
• These noises may be heard occasionally inside the refrigerator. This is normal.
This sound occurs when various items contract or expand while temperatures are
changing; especially during defrosting. This may also occur when electronic de-
vices including the ice maker are operating.
Leveling & Door Alignment
• Insert a flat-blade screwdriver into a
slot on the control lever, turn it clock-
wise or counter-clockwise to level the
Food stored in refrigerator is frozen
• If food with too much moisture is stored near the cooling vents, it may get frozen.
Be sure to keep moist food away from the cooling vents.
door.
Control Lever
Screwdriver
Moving and Installing
• Open the freezer drawer to gain an ac-
cess to the adjustable hinge pin. Next,
adjust the refrigerator door using the
provided 0.16 inch wrench.
• When installing, servicing or cleaning
behind the refrigerator, be sure of the
following:
RAISE
• To protect your floor’s finish when
moving the refrigerator, cut a large
section of the cardboard carton and
place under the refrigerator where
you are working.
• If you need to add more height to the
door, insert the provided snap rings.
• Pull the unit straight out and push
back in straight after finishing.
DA99-02015A REV(0.0)
ENGLISH
|